Bend Metal Without Marking It. 100mm and 150mm
Bending metal can sometimes result in a less than perfect finish. Especially when working with stainless steel or aluminium. Simply by using No-Mar from Aotea, you can greatly reduce or even eliminate marks or defects caused by your press brake die. Made of ultra strong polyurethane, No-Mar provides high friction resistance during correct bending application and one piece of film can be used over and over again.
- NO-MAR PRESS BRAKE DIE FILM is available in both 100mm and 150mm widths. Simply cut it to the length required and placed it over your press brake die.
- NO-MAR PRESS BRAKE DIE FILM can be used with any press die or material. Once positioned, either tape or clamp it in place.
- BEND YOUR MATERIAL as you would normally. Depending on the material, its thickness and the force applied – No-Mar Press Brake Die Film can be used many times over.
- 100 mm OR 150 mm wide
Length of roll:
- 30 m
- 0.015 mm
5% OFF IF YOU BUY A BOX
- 100 mm Box: 12 rolls
- 150 mm Box: 8 rolls